Be careful to avoid discharging any static electricity on the boards.

If the TWR-LCD-RGB is not already assembled in one piece with the
secondary elevator, firmly attach the TWR-LCD-RGB to the secondary
elevator that was furnished with the TWR-LCD-RGB.  Do this by placing
the secondary elevator on a table with its black connectors labeled
"Slot 1" through "Slot 4," touching the table.  Then, with the
TWR-LCD-RGB correctly seated in the connectors on the top side of the
secondary elevator (these are labeled "C Side Expansion Port" and "D
Side Expansion Port"), firmly press the printed circuit board (PCB) of
the TWR-LCD-RGB downward to completely seat the connectors together.
DO NOT PRESS ON ANY PART OF THE ACTUAL LCD DISPLAY -- ONLY PRESS ON
THE PCB TO WHICH THE DISPLAY IS ATTACHED.  See the photo on the web
site to ensure that have correctly positioned the secondary elevator
and the TWR-LCD-RGB and that you are pressing on the printed circuit
board in the correct locations.

Install the CR 2025 3V button battery in the battery holder labeled
"Bat" on the underside of the TWR-K70F120M board.  Please observe the
polarity with the side of the battery labeled "+" touching the battery
holder casing also labeled "+".

Assemble the Freescale Tower with the TWR-K70F120M board on the top of
the elevators.  The top is the end of the elevators where the
connectors on the elevators are closest to the edge.  On both the
primary and secondary elevators, the uppermost connector is labeled
"Slot 4" and the lowermost connector is labeled "Slot 1."

Make sure that the primary elevator (the one with white connectors) is
connected to the end of the TWR-K70F120M board with a white stripe and
labeled "primary."  The other end of the TWR-K70F120M board has no
stripe and is labeled "secondary."  At this time, only assemble the
primary elevator to the TWR-K70F120M.

Assemble the Tower with the TWR-SER board at the bottom on the
elevators.  Again, make sure that the primary elevator is connected to
the end of the TWR-SER board with the white stripe and labeled
"primary."  The other end of the TWR-SER board has no stripe and is
labeled "secondary."  At this time, only assemble the primary elevator
to the TWR-SER.

Now, with both the TWR-K70F120M and the TWR-SER assembled to the
primary elevator, assemble the secondary elevator with the attached
TWR-LCD-RGB display to both the TWR-K70F120M and the TWR-SER boards'
secondary elevator connectors.

Attach the USB cable that came with the TWR-K70F120M from the mini USB
jack on the TWR-K70F120M to a USB jack on a Windows computer.


Note that for some TWR-LCD-RGB modules to function correctly, an
external 5 Volt USB power supply (or "charger") of at least 1 Amp
output with a mini-B plug may be required to be plugged into the
mini-B jack on the outside lower left edge of the Primary Elevator.
Ensure that the three-position slide switch on the outside lower right
edge of the Primary Elevator is moved to the uppermost "USB" position.